OE 45671-4G644 — Pressure Plate 2 8 Brake for Hyundai

Incoming batches pass a dimensional check, a material look-up against the brake system specification, and a visual inspection for finish defects. Critical dimensions are measured per carton and the photographs are archived against the order number.

A supersession happens when the maker revises a pressure plate 2 8 brake and issues a new tail number. The revision normally changes a small physical detail rather than the fit. Where we know a supersession chain for 45671-4G644 we list the current reference; ask our desk for written confirmation before a large order.

Three checks: the code printed on your old part must read 45671-4G644; the number must fall inside the build-year range in the Applications table; and the connector, thread or bolt pattern must match the reference photo. Codes cast into the housing are the most reliable source.

OE 45671-4G644 is the factory reference for this pressure plate 2 8 brake on selected Hyundai models. The Applications table on this page lists the confirmed rows — check trim level and build year against your own fleet before ordering, because one reference can cover several body variants.

Treat it as a wear item: inspect every 20,000-30,000 km and replace at the first sign of leakage, noise or performance loss. Real service life swings widely with climate, road surface and duty cycle, so mileage on its own is a weak indicator.

Standard minimum order is 10 pieces per part number. Mixed orders that combine 45671-4G644 with other brake system references are welcome — that is how most clients fill an LCL or FCL container without over-stocking a single line.